Tips for invisible members
Page 1 of 1
Re: Tips for invisible members
Thank you for the tutorial, I have been looking for it for a while.
Invité- Guest
Re: Tips for invisible members
I have a different way of doing it....Make the body as small as you can for at least 3 spine segments then take a limb (for this i generally do this at the ends of the body...it is easier for me that way) ...I generally take the very first limb then place it on the part of the body you made a small as possible, once you have this you then take the limb where it connects to the body and put it as close to the top of the body without coming off. Then take the connecting joint and make it one limb, then take the first joint of the limb after the connecting joint and move it out a ways so you can make the connecting joint as big as possible. Make the connecting joint as big as possible and then move the joint after the connecting joint up...you should see the limb move up "off the body," once you have done this shrink the connecting joint as small as possible and it should go away, If it doesn't become invisible try the process over again...If it still wont become invisible move the joint after the connecting joint up and it should go invisble....Hope this helps
*If you don't fully understand it I will type out the instructions I have for this* **Hope I helped **
*If you don't fully understand it I will type out the instructions I have for this* **Hope I helped **
Invité- Guest
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum